Differences

This shows you the differences between two versions of the page.

--- tools [2018/07/31 16:22] – [CANUSB module] athery
+++ tools [2021/07/30 10:56] (current) – [FLIR camera] damien
@@ Line 101: / Line 101: @@
+===== USB-I2C (USB-ISS) module =====
+from [[https://www.robot-electronics.co.uk/htm/usb_iss_tech.htm]]
+To be used with [[https://github.com/milidam/devantech | i2c-devantech-iss]] kernel module, to access a dedicated ''/dev/i2c-x'' device on one's Linux desktop.
+Then you can use the ''/dev/i2c-x'' device directly, or request another kernel module to use it:
+<code>
+echo <your_module> <device_address> > /sys/bus/i2c/devices/i2c-<x>/new_device
+</code>
+When using ''zsh'', the latest command may result into failure ''zsh: file exists: /sys/bus/i2c/devices/i2c-<x>/new_device''; in that case, just switch to //bash//, and the same command will succeed.
+===== FLIR cameras =====
+==== PureThermal2 USB module ====
+https://groupgets.com/manufacturers/getlab/products/purethermal-2-flir-lepton-smart-i-o-module
+https://lepton.flir.com/getting-started/
+On Ubuntu, can be used with the [[https://github.com/groupgets/GetThermal|GetThermal interface]].
+==== FLIR ONE PRO ====
+Normally foressen to work with Android.
+But can be used on Linux using [[https://source.dpin.de/nica/flir-gtk|flir-gtk]]((on Ubuntu < 20.04, this requires the amnual install of https://github.com/DaveGamble/cJSON)).
+See also https://www.dpin.de/nf/thermal-camera-on-linux-flir-one-pro/.